TheBrim® Linny + Cinny for RED

SKU:

$890.00

$777.00

$777.00

Unavailable

per item

​Linny Kit + Cinny for RED

​Advanced subtractive color modeling LUT Kit for RED IPP2 - REDLogFilm and Log3g10. 

The kit includes the following LUTs in 17x17x17, 32x32x32 and 64x64x64 sizes of .CUBE files:

• TheBrim® Log3g10 Linny 
• TheBrim® Log3g10 Linny + Print B1 
• TheBrim® Log3g10 Linny + Print B2
• TheBrim® Log3g10 Linny + Print B3
• TheBrim® Log3g10 Linny + Print B4
• 
  
• TheBrim® REDLogFilm Linny 
• TheBrim® REDLogFilm Linny + Print B1 
• TheBrim® REDLogFilm Linny + Print B2
• TheBrim® REDLogFilm Linny + Print B3
• TheBrim® REDLogFilm Linny + Print B4
• TheBrim® REDLogFilm Cinny 

Variants with Infrared Pollution Control:

• TheBrim® REDLogFilm Linny IRC
• TheBrim® REDLogFilm Linny + Print B1 IRC
• TheBrim® REDLogFilm Linny + Print B2 IRC
• TheBrim® REDLogFilm Linny + Print B3 IRC
• TheBrim® REDLogFilm Linny + Print B4 IRC

I/O spec:

• Linny is intended for Rec.709/Gamma 2.2 deliverables and should be appropriately converted from there if different spec deliveries are required. 
• Linny for RED expects RED Wide Gamut RGB/Log3G10 or REDcolor(2/3/4)/REDLogFilm on input.
• Cinny for RED expects REDcolor(2/3/4)/REDLogFilm on input.

USEFUL TIPS:

• Apply exposure changes before / underneath the LUT. We advise affecting only the luminance with these exposure changes, without changing the saturation levels or chrominance levels.

• In case of Out-of-Gamut / Edge-of-Gamut colors correct either the color saturation level or luminance level of that specific color before / underneath the LUT. 

• For general best performance and in case of "banding" or other artefacting within DaVinci Resolve be sure to switch to an appropriate LUT interpolation algorithm. You can do this in DaVinci Resolve by going to "Settings" then to the “Color Management“ tab, under “3D Lookup Table Interpolation” switch to “Tetrahedral”.

Current Version: Block 1

Quantity

Add to Cart